KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual page 192

9 Installation
5. Turn the head support to PA position.
6. Pull the left hand side of the upper head support cover over the head support mount.
7. Turn the head support to LAT position and remove the cover.
8. Loosen the ear rod height locking screws (2 pcs) and adjust the eccentric screw to
lift/lower the ear holder as required.
NOTICE! The ear rod assembly has height indicators to be used as guides.
9. Re-tighten the ear rod height locking screws.
10. Verify the correct ear rod height by performing the CEPH position calibration.
192
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
ORTHOPANTOMOGRAPH
D519207, 19
™
OP 3D