KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual page 107

13. Tighten the 2 lower CEPH arm joint bar screws.
14. Tighten the 2 upper CEPH arm joint bar screws.
NOTICE! There are holes on the bottom of the CEPH arm that allow you to
use a long allen key to tighten the screws. After tightening the screws, cover
the holes with the supplied cover plugs.
15. Adjust the depth of the CEPH arm leveling bolt until the CEPH arm is approximately
horizontal.
NOTICE! The final adjustments for the CEPH arm alignment is done during
the calibrations.
ORTHOPANTOMOGRAPH
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
™
OP 3D
9 Installation
107
D519207, 19