KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual page 113

3. Tighten the wall bracket arm pivot screw and attach the screw cap.
4. Install the wall bracket cover plate in place with 2 screws.
5. Connect the mains cord (1), Ethernet cable (2) and exposure switch cable (3) to the
rear of the carriage.
NOTICE! Route the Ethernet cable and exposure switch cable through the
strain relief.
NOTICE! You can also connect other additional cables to the carriage at this
point. See chapter
NOTICE! The cables will move when the unit is driven upwards. Ensure that
the cables connected to the device are long enough so that the unit can be
driven to upmost position without causing any strain to the cables.
ORTHOPANTOMOGRAPH
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
Back panel connectors
™
OP 3D
on page 86.
9 Installation
113
D519207, 19