KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual page 58

6 Using the device
5. Attach the carpus holder by sliding it to the base of the nasion support.
6. Adjust the device's height if needed.
7. Ask the patient to remove any jewellery and all other things that may cause artifacts
to the image.
8. Protect the patient from radiation according to the local regulations, for example
using a lead apron.
9. Ask the patient to place their palm against the carpus holder with their fingers
spread apart and wrist straightened. The palm of the hand should face the sensor.
NOTICE! Only the center area of the carpus holder is exposed. Ensure that
the patient's hand is positioned so that the imaged parts are on the center
area of the carpus holder (white area in the image above).
NOTICE! You may place the patient's hand diagonally on the carpus holder if
it doesn't fit properly otherwise.
NOTICE! To ensure optimal image quality, pay attention to the correct
patient positioning.
58
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
ORTHOPANTOMOGRAPH
D519207, 19
™
OP 3D