KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual page 108

9 Installation
16. Detach the tubehead handle screw and remove the handle by pulling it off the
tubehead.
17. Detach the mirror opto cable and loosen the mirror base plate screws (3 pcs).
18. Lift the mirror base plate off the device.
19. Guide the tubehead cable bundle containing the tubehead cable set (large 3-pin
connector and 14-pin connector) and the grounding cable through the opening on
the CEPH arm.
108
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
ORTHOPANTOMOGRAPH
D519207, 19
™
OP 3D