KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual page 106

9 Installation
9. Turn the straight CEPH arm half against the other arm half until it locks in place.
NOTICE! Once the arm is in correct position, a latch inside the straight CEPH
arm locks the arm in place.
10. Attach the 2 indicated screws (M8x16) to the CEPH arm joint bar to finger tightness.
NOTICE! You may need to lift the tubehead a little to align the screw holes
properly.
11. Attach the arm alignment screw with a conical washer to the CEPH arm joint bar.
12. Tighten the arm alignment screw until the gap between the 2 CEPH arm halves is
closed.
106
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
ORTHOPANTOMOGRAPH
D519207, 19
™
OP 3D