Final Steps Of Device Installation - KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual

9 Installation

9.4.4 Final steps of device installation

1. If the column was previously attached to the floor using only the pivoting screw, fix
the column to the floor.
a) Rotate the device to the correct installation angle.
b) Check that the column is still vertically level. If it's not level, adjust the tilt of the
column according to the column tilt adjustment instructions in step
95.
c) Tighten the wall bracket screws.
d) Drill appropriate holes for the floor fixing hardware through the corner holes on
the column floor plate.
e) Fix the column to the floor using appropriate screws and washers.
f) Re-attach the pivot screw cover on the column floor plate.
2. Attach the column base caps over the screw heads.
112
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
26 on page
ORTHOPANTOMOGRAPH
D519207, 19
™
OP 3D