Back Panel Connectors - KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual

9 Installation

9.3 Back panel connectors

1. Power cord
2. Ethernet cable for workstation connection
3. Exposure button connector
4. Remote exposure switch connector (optional)
5. External warning light connector (optional)
6. Main fuses F1+F2 (10A fuses installed as default)
7. External warning light (optional) fuse F3
8. Control interface
NOTICE! All cables, except the power cord, must be routed through a strain relief
attached to the back panel plate.
The Control interface can be used to connect optional device controls such as external
exposure switch and door switch.
PIN
USE
NOTICE! If a door switch is installed it has to be activated on the GUI. See
chapter
86
Reviewed Suuronen Esa 2019-09-19 12:21
Approved Lassinen Juuso 2019-10-02 14:37
1 2
Exposure switch LOW signal when
connection device is READY
Device settings on page 158 for more information.
3 4 5
Ground +5V
6 7
LOW signal when Door switch
exposure is ON connection
ORTHOPANTOMOGRAPH
D519207, 19
8
™
OP 3D