Configuring Round-Trip Delay Thresholds; Establishing The Configuration Task - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Procedure
Step 1 Run the display nqa-agent [admin-name test-name ] [ verbose ] to view the status of the test
instance configured on the NQA client.
----End
Example
<Quidway> display nqa-agent
nqa test-instance a a
test-type pwe3trace
local-pw-id 1
vc-type bgp
nqa status : normal
nqa test-instance a b
test-type icmpjitter
destination-address ipv4 100.1.1.201
source-address ipv4 100.1.1.200
hardware-based enable
ttl 100
tos 100
timeout 20
nqa status : normal

6.24 Configuring Round-Trip Delay Thresholds

This section describes how to set a round-trip delay transmission threshold in an NQA test
instance.

6.24.1 Establishing the Configuration Task

Before setting a round-trip transmission delay threshold, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This can help
you complete the configuration task quickly and accurately.
Applicable Environment
If the round-trip transmission delay threshold is configured for a NQA test instance, the NQA
test result will contain the statistics on the test packets that exceed the set threshold. This provides
the basis for the network manager to analyze the operation status of the specified service.
Pre-configuration Tasks
Before configuring the round-trip transmission delay threshold, complete the following tasks:
l
l
Data Preparation
To configure the round-trip transmission delay threshold, you need the following data.
Issue 01 (2011-10-26)
Running the device normally
Creating NQA test instances and configuring related parameters correctly
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
325