ELECTRONIC FUEL INJECTION SYSTEM (G13/G16 ENGINE WITHOUT WU TWC) 6E1-103
EVAP CANISTER PURGE VALVE INSPECTION
1) With ignition switch OFF, disconnect coupler from canister air
2) Check resistance between two terminals of EVAP canister
1. EVAP canister purge valve
3) Disconnect vacuum hoses from intake manifold and its pipe.
1. Hose "A"
2. Nozzle "B"
4) With coupler disconnected, blow into hose "A". Air should not
5) Connect 12V-battery to EVAP canister purge valve terminals. In
1. Hose "A"
2. Nozzle "B"
6) Connect vacuum hoses.
7) Connect EVAP canister purge valve coupler securely.
valve.
purge valve.
Resistance of EVAP canister purge valve:
30 – 34 W at 20 C (68 F)
If resistance is as specified, proceed to next operation check.
If not, replace.
come out of hose "B".
this state, blow hose "A".
Air should come out of hose "B".
WARNING:
Do not suck the air through valve. Fuel vapor inside
valve is harmful.
If check result is not as described, replace canister purge valve.