Suzuki Baleno Manual page 1799

ELECTRONIC CONTROL SYSTEM
The electronic control system consists of 1) various
sensors which detect the state of engine and driving
conditions, 2) ECM which controls various devices ac-
cording to the signals from the sensors and 3) various
controlled devices.
Functionally, it is divided into the following sub sys-
tems:
D Fuel injection control system
D Ignition control system
NOTE:
Above figure shows left-hand steering vehicle. For right hand steering vehicle, parts with (:) are installed at
the other side.
INFORMATION SENSORS
1. MAF sensor
2. TP sensor
3. IAT sensor
4. ECT sensor
5. Heated oxygen sensor (if equipped)
6. VSS
7. A/C amplifier (if equipped) (:)
8. Battery
9. PSP switch (if equipped)
10. CMP sensor
11. CO adjusting resistor (:)
ELECTRONIC FUEL INJECTION SYSTEM (J18 ENGINE WITHOUT WU TWC) 6E3-7
D Idle air control system
D Fuel pump control system
D Radiator fan control system
D Evaporative emission control system (if equipped)
D EGR system (if equipped)
D Heated oxygen sensor heater control system
(if equipped)
D A/C condenser fan control system (if equipped)
CONTROL DEVICES
a : Fuel injector
b : EVAP canister purge valve (if equipped)
c : Fuel pump relay
d : EGR valve (if equipped)
e : Malfunction indicator lamp
("CHECK ENGINE" light) (:)
f : A/C condenser fan control relay
(if equipped)
g : Radiator fan control relay
h : IAC valve
i : Ignition coil assembly (with ignitor)
OTHERS
A : ECM (:)
B : TCM (:)
C: Main relay
D: ICM (:)
E : EVAP canister
F : Diagnosis connector-1
G: Data link connector (:)
H: J/B (:)