High Pressure Pipe Between Rails: Removal - Refitting - Renault Laguna III Manual

High pressure pipe between rails: Removal - Refitting
V9X
Special tooling required
Mot. 1448 Remote operation pliers for
hose clips.
Mot. 1566 Tool for removing high pres-
sure pipes.
Equipment required
Diagnostic tool
Tightening torquesm
nut of the high pressure
pipe between the rails
on the front row rail
nut of the high pressure
pipe between the rails
on the back row rail
IMPORTANT
Consult the safety and cleanliness advice and oper-
ation recommendations before carrying out any
repair (see 13B, Diesel injection, Diesel injec-
tion: Precautions for the repair, page 13B-1) .
IMPORTANT
Use the diagnostic tool before any operation is car-
ried out on the injection circuit to check:
- that the rail is not under pressure,
- that the fuel temperature is not too high.
Working on the circuit with the engine running is
strictly forbidden.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
WARNING
To prevent impurities from entering the circuit, place
protective plugs on all fuel circuit components
exposed to the open air.
DIESEL INJECTION
30 N.m
30 N.m
13B-184
WARNING
To avoid any corrosion or damage, protect the
areas on which fuel is likely to run.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine cover,
- the engine undertray bolts,
- the engine undertray,
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection).
13B