Cfm Endpoint: Mip Slot Screen - ZyXEL Communications MSC1000G User Manual

Chapter 13 Switch Screens
Table 289 CFM Endpoint: MIP (continued)
LABEL
MSC1000G
Apply
Slot
Port
Load
Enable
Apply
Cancel
ID
State
Card Type
Up Time
Firmware

13.19.4 CFM Endpoint: MIP Slot Screen

In the CFM Endpoint: MIP screen, click the ID of a line card to display the screen shown next. This
screen lists the MIP setting for each of the line card's ports.
544
DESCRIPTION
Select Enable and specify a MAC address to set a MIP on an MSC port.
Click Apply to save the changes in this section to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Use the drop-down list boxes to select a DSL port on a line card for which you want to
configure MIP settings.
Click Load to display the port's current settings.
Select Enable and specify a MAC address to set a MIP on a DSL port.
Click Apply to save the changes in this section to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to reset the fields.
This is the slot number of a line card. Click the index number of an active line card to
display a screen that lists the MIP setting for each of the line card's ports.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See
on page 1111 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
Section 38.7
Management Switch Card User's Guide