Profile Alarmvdsl Set Command - ZyXEL Communications MSC1000G User Manual

Chapter 30 profile Commands
This command displays the details of the specified alarm VDSL profile or lists all of the alarm VDSL
profiles if you do not specify one.
The following example displays the default alarm VDSL profile (DEFVAL).
ras> profile alarmvdsl show DEFVAL
vdsl alarm profile : DEFVAL
initFailure(ift)
15MinLofs(lofs)
15MinLoss(loss)
15MinLols(lols)
15MinLprs(lprs)
15MinESs(ess)
15MinSesL(sesl)
15MinUasL(uasl)
ras>

30.9.2 profile alarmvdsl set Command

Syntax:
profile alarmvdsl set <profile> [lofs <lofs>] [loss <loss>] [lols <lols>] [lprs
<lprs>] [ess <ess>] [sesl <sesl>] [uasl <uasl>] [ift <ift>]
where
<profile>
<lofs>
<loss>
<lols>
<lprs>
<ess>
<sesl>
<uasl>
<iru>
<ift>
The
alarmprofile set
alarm trap and generates a syslog entry when the thresholds of the alarm profile are exceeded.
Configure
alarmvdsl
them with specific VDSL ports.
876
:
(sec):
(sec):
(sec):
(sec):
(sec):
(sec):
(sec):
=
A name for the alarm profile (up to 31 English keyboard characters).
= The number of Loss Of Frame Seconds (0~900) that are permitted to occur within
15 minutes.
=
The number of Loss Of Signal Seconds (0~900) that are permitted to occur within
15 minutes.
=
The number of Loss Of Link Seconds (0~900) that are permitted to occur within 15
minutes.
= The Number of Loss of PoweR seconds (0~900) permitted to occur (on the ATUR)
within 15 minutes.
= The number of Errored SecondS (0~900) that are permitted to occur within 15
minutes.
=
The number of Severely Errored Seconds (0~900) that are permitted to occur
within 15 minutes.
=
The number of UnAvailable Seconds (0~900) that are permitted to occur within 15
minutes.
= A rate in kilobits per second (Kbps). If an interleave mode connection's upstream
transmission rate increases by more than this number, then a trap is sent.
=
"1" sets the profile to trigger an alarm for an initialization failure trap. "0" sets the
profile to not trigger an alarm for an initialization failure trap.
command configures VDSL port alarm thresholds. The system sends an
profiles first and then use the
-
0
0
0
0
0
0
0
port vdsl alarmprof
Management Switch Card User's Guide
command to use