ZyXEL Communications MSC1000G User Manual page 773

Table 364 port Commands (continued)
COMMAND
uscarrier
virtualnoise
vlan
xvlan
vdsl2 alarmprof
dt
Management Switch Card User's Guide
<slot-port> <m0> <m1>
ds disable <slot-
port>
ds enable <slot-port>
ds set <slot-port>
{<tone> <psd> [<tone>
<psd>...]}|empty
us disable <slot-
port>
us enable <slot-port>
us set <slot-port>
{<tone> <psd> [<tone>
<psd>...]}|empty
<slot-port> <vid>
<registration> <tag>
delete <slot-port>
<cvid>
set <slot-port>
<cvid> <svid> <cvid-
s>
show <slot-port>
<slot-port> <profile>
disable <slot-port>
enable <slot-port>
DESCRIPTION
Disables upstream carrier tones (from 0~63).
For example, setting m0 to "80" and m1 to "0"
means to disable upstream carrier tone 8.
m0, m1: carrier tones mask, 0~ffffffff. Set the value
to 1 to disable the corresponding tone. m0
represents tones 0~31 and m1 represents tones
32~63.
Disables virtual noise for downstream transmission
on a port.
Enables virtual noise for downstream transmission
on a port.
Configures a port's virtual noise settings for
downstream transmission.
tone: the index of a tone, 1~4096
psd: Power Spectral Density, 0~200 represents a
PSD of -140+psd/2 dBm/Hz.
Disables a port's virtual noise for upstream
transmission.
Enables a port's virtual noise for upstream
transmission.
Configures a port's virtual noise settings for
upstream transmission.
tone: the index of a tone, 1~4096
psd: Power Spectral Density, 0~200 represents a
PSD of -140+psd/2 dBm/Hz.
Sets the VLAN setting on the VDSL port(s).
Removes the specified XVLAN entry (cvid) from the
specified port.
Creates an XVLAN entry for the specified port.
cvid is the original customer VLAN ID. When the
port receives traffic from the subscriber with a
cvid VLAN tag, XVLAN changes it to the svid
before forwarding it to the service provider's
network. The VLC13XXG's XVLAN can also include
a translated customer VLAN ID (cvid-s).
Displays the XVLAN settings for the specified port.
Sets the VDSL2 alarm profile that the specified
port uses.
Note: These port vdsl2 commands only support
the VLC14xx line cards.
Disables double tagging on a port.
Note: These port vdsl2 dt commands only
support the VLC14XX line cards.
Enables double tagging on a port.
Chapter 29 port Commands
P
8
8
8
8
8
8
8
8
8
8
8
8
8
8
773