Anti-Mac Spoofing Screen - ZyXEL Communications MSC1000G User Manual

Chapter 4 Access Control List Screens
Figure 52 ACL > Rule
The following table describes the labels in this screen.
Table 35 ACL > Rule
LABEL
Slot
Port
VPI/VCI
ACL Profile
Nomatch
Apply
Cancel
Slot
Port
Load
Index
VPI/VCI
ACL Profile
Select
Cancel

4.17 Anti-MAC Spoofing Screen

With anti-MAC spoofing enabled, a line card that detects MAC address spoofing (another device
using a MAC address that is connected to another subscriber port on the system) disables the
subscriber port where it detected the spoofed MAC address. A VDSL or Ethernet line card, the line
card re-enables the port after five minutes.
116
DESCRIPTION
Use the drop-down list boxes to select a DSL line card and port for which to apply ACL
profiles to a PVC.
For an ALC or SLC port, select this check box and type the Virtual Path Identifier and Virtual
Circuit Identifier for a channel on the port.
Select the ACL profile to apply to the selected PVC.
Select whether to forward (accept) or drop (deny) traffic that does not match any of the
rules in the ACL profile. This only applies to the VLC13XXG, VLC14XXG, ELC, and the GLC.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Use the drop-down list boxes to select a DSL line card and port.
Click Load to display the port's current settings.
This is the index number of an entry.
For an ALC or SLC port, this field displays the Virtual Path Identifier (VPI) and Virtual Circuit
Identifier (VCI)
This field displays the ACL profile the system applies to the PVC.
Select this check box (or use Select All to select every check box) and then click the
Delete button to remove an ACL profile from the PVC.
Click Cancel to begin configuring the screen again.
Management Switch Card User's Guide