Switch Lldp Port Adminstatus Command - ZyXEL Communications MSC1000G User Manual

This command displays the LLDP settings and statistics. The following is an example.
ras> switch lldp show
Status
TX Interval
TX Hold Time
Reinit Delay
TX Delay
Notify Interval : 120 sec
port admin_st notify
------ -------- ------- ------
enet1 disable
enet2 disable
enet3 disable
enet4 disable
enet5 disable
enet6 disable
enet7 disable
enet8 disable
Remote Tables Last Change Time : 00:00:00
Remote Tables Inserts
Remote Tables Deletes
Remote Tables Drops
Remote Tables Ageouts

33.9.9 switch lldp port adminstatus Command

Syntax:
switch lldp port adminstatus <port> disable|tx|rx|tx-rx
where
disable
tx
rx
tx-rx
This command sets how the MSC uses LLDP on this port.
The following example sets the MSC's port 2 to receive remote LLDP information.
ras> switch lldp port adminstatus enet2 rx
33.9.10 switch lldp port flush Command
Syntax:
switch lldp port flush <port>
Management Switch Card User's Guide
: active
: 10 sec
: 10 cycles
: 5 sec
: 16 sec
tlv
enable 0xd51f
enable 0xd51f
enable 0xd51f
enable 0xd51f
enable 0xd51f
enable 0xd51f
enable 0xd51f
enable 0xd51f
: 0
: 0
: 0
: 0
= This has the MSC not send or receive LLDP information through this port.
=
This has the MSC send local LLDP information through this port.
=
This has the MSC receive remote LLDP information through this port.
=
This has the MSC send local LLDP information and receive remote LLDP
information through this port.
Chapter 33 switch Commands
1011