Multicast Commands - ZyXEL Communications MSC1000G User Manual

This chapter shows you how to use the
28.1 multicast Commands Summary
The following table lists the
administrator privilege level needed to use the command.
Table 362 multicast Commands
COMMAND
multicast bandwidth
groupmacaddr del
igmp
Management Switch Card User's Guide
C
multicast
commands. The P column on the right indicates the
multicast
default <bandwidth>
delete <index>
port disable <slot-
port>
enable <slot-port>
set <slot-port>
<bandwidth>
show <slot>|<slot-
port>
set <index> <start-
mcast-ip> <end-
mcast-ip>
<bandwidth>
show
<vid> <group-mac-
addr>
set <vid> <group-mac-
addr> <giga-
port>|<slot-port>
fix|forbid
show <vid> <group-mac-
addr>
disable
HAPTER

multicast Commands

commands.
DESCRIPTION
Sets the default bandwidth (1 ~100 000
kbps) allowed for multicast channel(s) for
which you have not set the bandwidth
settings.
Removes the specified multicast bandwidth
configuration.
Deactivates multicast bandwidth setting on
a port.
Activates multicast bandwidth setting on a
port.
Sets the maximum multicast bandwidth
allowed on a port.
Displays multicast bandwidth settings on
the specified line card or port.
Sets bandwidth allowed for the specified
multicast channel(s).
Displays multicast bandwidth settings on
the device.
Removes a static multicast group entry by
MAC address.
Configures static MAC multicast to allow
incoming frames based on multicast MAC
address(es) that you specify.
Displays the settings of a static multicast
MAC address.
Turns off IGMP proxy or snooping.
2 8
P
8
8
8
8
8
1
8
1
8
8
1
8
735