ZyXEL Communications MSC1000G User Manual page 66

Chapter 3 The Web Configurator
Table 3 Navigation Panel Links (continued)
LINK
Current Alarm
History Alarm
Alarm Port
Setup
Alarm Edit
Alarm Clear
Alarm Input
Diagnostic
LDM
Loopback
IP Ping
IP Trace Route
MLT
CFM Loopback
CFM Linktrace
SELT
OAM Loopback
IMA Loopback
Maintenance
Config Backup
Config Restore
Config Reset
Config Server
Firmware
Upgrade
Reboot
AlmHis Backup
Multicast
IGMP
IGMP History
Static Multicast
66
DESCRIPTION
This link takes you to a screen where you can display current detailed alarms by severity or
time period.
This link takes you to a screen where you can display historical alarms by severity or time
period.
This link takes you to a screen where you can set the severity level of alarms to record on
specified ports.
This link takes you to a screen where you where you can configure the log facility, message
type and severity of the alarm categories.
This link takes you to a screen where you can erase alarm entries.
This link takes you to a screen where you can configure the names for external alarms.
This link takes you to a screen where you can perform LDM (Loop Diagnostic Mode) tests
on a subscriber port.
This link takes you to a screen where you can perform an OAM (Operational, Administration
and Maintenance) F5 loopback test on a subscriber port or PVC.
This link takes you to a screen where you can ping a host.
This link takes you to a screen where you can send a traceroute packet to an IP address
and use the response to determine the path a packet takes to that IP address.
This link takes you to a screen where you can test the lines connected to VOP ports.
This link takes you to a screen where you can perform a connectivity fault management
loop back test.
This link takes you to a screen where you can perform a connectivity fault management
link trace test.
This link takes you to a screen where you can perform a SELT (Single End Loop Test) on a
port to check the distance to the subscriber's location.
This link takes you to a screen where you can perform an Ethernet OAM (Operational,
Administration and Maintenance) loopback test to a remote Ethernet device.
This link takes you to a screen where you can perform an E1, IMA or F5 loopback test to a
remote ADM (Add-Drop Multiplexer) device.
This link takes you to a screen where you can back up your current system configuration.
This link takes you to a screen where you can restore a previously saved configuration.
This link takes you to a screen where you can reset the system back to the factory
defaults.
This link takes you to a screen where you can configure an FTP or a TFTP server for the
MSC's configuration file downloading or uploading.
This link takes you to a screen where you can upload a new firmware.
This link takes you to a screen where you can restart the system.
This link takes you to a screen where you can back up the system's alarm history to your
computer.
This link takes you to screens where you can enable or disable IGMP proxy or IGMP
snooping and assign IGMP filter profiles to subscriber ports.
This link takes you to a screen where you can enable and disable IGMP historical data
collection. You can also clear all IGMP historical data on this screen.
This link takes you to a screen where you can configure static multicast group entries.
Management Switch Card User's Guide