Chapter 30 profile Commands
30.10 profile atm Commands
Use these commands to configure ATM traffic settings.
30.10.1 profile atm show Command
Syntax:
profile atm show [<profile>]
where
profile
This command displays the details of the specified ATM profile or lists all of the ATM profiles if you
do not specify one.
The following example displays the DEFVAL ATM profile.
ras> profile atm show DEFVAL
atm profile: DEFVAL
traffic class: ubr
pcr
cdvt
ras>
30.10.2 profile atm set Command
Syntax:
profile atm set <atmprofile> cbr|ubr <pcr> <cdvt>
or
profile atm set <atmprofile> rt-vbr|nrt-vbr <pcr> <cdvt> <scr> <bt>
where
<atmprofile>
<ubr|cbr>
<pcr>
[cdvt]
rt-vbr|nrt-vbr
<scr>
878
A profile name.
: 300000
: 0
The name of the ATM profile (up to 31 English keyboard characters). You cannot
change the DEFVAL profile.
The ubr (unspecified bit rate) or cbr (constant bit rate) ATM traffic class.
Peak Cell Rate (150~300000), the maximum rate (cells per second) at which the
sender can send cells. * sets the default value.
Cell Delay Variation Tolerance is the accepted tolerance of the difference between
a cell's transfer delay and the expected transfer delay (number of cells). 0 to 255
cells or * for the default value.
The Real-Time Variable Bit Rate (vbr) or Non Real-Time Variable Bit Rate (nrt-vbr)
Variable Bit Rate ATM traffic class.
The Sustainable Cell Rate (150~300000) sets the average cell rate (long-term)
that can be transmitted (cells per second). SCR applies with the vbr traffic class. *
sets the default value.
Management Switch Card User's Guide