ZyXEL Communications MSC1000G User Manual page 150

Chapter 5 Alarm Screens
The following table describes the labels in this screen.
Table 57 Alarm Port Setup
LABEL
sub1
sub2
up1
up2
Management
Apply
Slot
Port
Load
Severity
Apply
Cancel
Copy
ID
150
DESCRIPTION
Select the severity level from info, minor, major and critical for the alarms to record on
the specified port of the MSC.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Use the drop-down list boxes to select an DSL port on a line card for which you wish to
configure the severity level.
Click Load to refresh the whole screen.
Select the minimum severity level of alarms (info, minor, major or critical) that the
system records on the port.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy settings from one port to another port or ports.
1. Select the Select radio button of the port from which you want to copy settings
2. Click Copy.
3. Select to which line card you want to copy the settings.
4. Select to which ports on the line card you want to copy the settings. Use Select All to
select every port. Use Select None to clear all of the check boxes.
5. Click Apply to paste the settings.
This is the slot number of a line card. Click the index number of an active line card to
display the Alarm Port Setup Slot screen where you can view and copy settings from one
port to another port or ports on the selected line card.
Management Switch Card User's Guide