Show Ip6 Route Command - ZyXEL Communications MSC1000G User Manual

Chapter 32 show Commands
An example is shown next. See
ras> show ip6 prefix
Interface: In-band
Prefix
-------------------------- --------- --------- --------- ------ ----------
fe80::/64
Interface: Out-of-band
Prefix
-------------------------- --------- --------- --------- ------ ----------
fe80::/64

32.3.19 show ip6 route Command

Syntax:
show ip6 route
This command displays the IPv6 routing table. An example is shown next. See
page 479 for more details.
ras> show ip6 route
Interface: In-band
Address
------------------------------------- -------------------------------------
fe80::/64
fe80::213:49ff:fec9:8b5
ff01::/32
ff02::/32
Interface: Out-of-band
Address
------------------------------------- -------------------------------------
fe80::/64
fe80::213:49ff:fec9:8b3
ff01::/32
ff02::/32
32.3.20 show ipbpvc arpproxy Command
Syntax:
show ipbpvc arpproxy all
show ipbpvc arpproxy domain <domain-name>
show ipbpvc arpproxy edgerouter [<ip> <vid>]
show ipbpvc arpproxy interface [<ip/mask> <vid>]
956
Section 12.16.2 on page 478
vltime pltime
infinity infinity
vltime pltime
infinity infinity
Gateway/Interface Name
In-band
fe80::213:49ff:fec9:8b5
In-band
In-band
Gateway/Interface Name
Out-of-band
fe80::213:49ff:fec9:8b3
Out-of-band
Out-of-band
for more details.
expire onlink autonomous
Never TRUE TRUE
expire onlink autonomous
Never TRUE TRUE
Section 12.16.4 on
Management Switch Card User's Guide