ZyXEL Communications MSC1000G User Manual page 734

Chapter 27 lcman Commands
The following table describes labels in the example.
Table 361 lcman show Command: Detailed Information
LABEL
slot
uptime
f/w version
status
hardware sensor
temperature
voltage
module exist
module status
hardware version
hardware serial
number
firmware version
DSL driver version
DSL modem version
current voltage level
current temperature
734
DESCRIPTION
This is the slot number followed by the model of card that is installed or was last
installed in the slot.
This is how long the card has been active.
This is the release of firmware that the card is using.
The following columns display a "V" if an alarm has been detected. "-" displays if no
related alarm has been detected.
This displays the condition of the card's hardware monitor sensor.
This displays whether or not the card's measured temperature is within the configured
operating thresholds.
This displays whether or not the card's measured current is within the configured
operating thresholds.
This displays whether or not the card is installed.
This displays whether or not the installed card is up (active).
This is the version of the card's physical hardware.
This is the card's individual identification number assigned at the factory.
This is the release of firmware that the card is using.
This is the driver version that a DSL line card's DSL chip is using.
This is the release of modem code that a DSL line card is using.
These are the voltages (in volts) measured at the card's sensors. An "*" indicates the
voltage is outside of the configured thresholds.
These are the temperatures (in degrees Celsius) measured at the card's sensors. An
"*" indicates the temperature is outside of the configured thresholds.
Management Switch Card User's Guide