ZyXEL Communications MSC1000G User Manual page 292

Chapter 9 Subscriber Port Setup Screens
Table 132 Port > VoIP H248 Screen
LABEL
Copy
Slot
Start Port
End Port
Termination
Step
Apply
ID
State
Card Type
Up Time
Firmware
292
DESCRIPTION
Use this to assign a port's settings to other ports.
1. Click Copy. The following pop-up screen displays.
Figure 187 Copy Port Settings
2. Select the required slot from the drop-down list.
3. Select the port(s) to which you want to copy the settings. Use Select All to select
every port. Use Select None to clear all of the check boxes.
4. Click Apply to copy the settings, or click Cancel to close the window without
saving any changes.
Use the drop-down list boxes to select a range of ports on an active VoIP line card for
which to automatically configure names for their Terminations.
Enter the name for this range of ports' H.248 Termination. Enter up to 31
alphanumeric characters. Spaces are not allowed.
Enter the interval between numbers to add to the name you configure in the
Termination field.
For example, enter "test" in the Termination field and "1" in the Step field to name
the ports test1, test2, test3, and so on.
Click this to save your changes to the MSC's volatile memory. The MSC loses these
changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
This column displays the line card's slot number. Click a H.248 line card's number to
go to the card's H.248 Port Setup Line Card screen (see
where you can see and edit all a SIP line card's VoIP configuration in a single screen.
This displays Active if the line card is enabled, or - if a line card is not enabled.
This displays a line card's model name.
This field displays how long the line card has been running since it was started up.
This field displays the current firmware version installed on the line card.
Section 9.26 on page
Management Switch Card User's Guide
293)