ZyXEL Communications MSC1000G User Manual page 301

Figure 196 ENET Dot3ad Setup
The following table describes the labels in this screen.
Table 138 ENET Dot3ad Setup
LABEL
Group ID
Active
Dynamic (LACP)
Apply
Cancel
Slot
Port
Load
Group
Apply
Management Switch Card User's Guide
DESCRIPTION
This column displays the names of the trunk groups for the Ethernet line card's Ethernet
ports.
Select this check box to turn on a trunk group.
Select this check box to use Link Aggregate Control Protocol (LACP), to dynamically create
and manage the trunk group.
If the peer switch does not support LACP, clear this check box to use static trunking.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Select the number of an Ethernet line card's slot.
Select the number of a port on the Ethernet line card.
Click Load to display the port's settings in the field below.
Select the trunk group to which to add the selected port (or none to not have the port in
any trunk group). A trunk group can have up to four ports.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Chapter 9 Subscriber Port Setup Screens
301