ZyXEL Communications MSC1000G User Manual page 296

Chapter 9 Subscriber Port Setup Screens
The following table describes the fields in this screen.
Table 135 ENET Port Setup
LABEL
Slot
Port
Load
Enable
Customer
Information
TEL
Flow Control
Frame Type
PVID / Priority
Rate Limit Profile
Queue Rate Limit
Profile
Queue Schedule
VLAN
Dot3ad
PVLAN
XVLAN
SFP Tx Enable
Speed
Apply
296
DESCRIPTION
Select the number of a line card's slot. The corresponding subscriber port setup screen for
the type of line card you selected automatically displays.
Select the number of a port on the line card.
Click Load to display the port's settings in the fields below.
Select this check box to turn on this port.
Enter information to identify the subscriber connected to this port. You can use up to 31
printable English keyboard characters (including spaces and hyphens).
Enter information to identify the telephone number of the subscriber connected to this
port. You can use up to 15 English keyboard characters (including spaces and hyphens).
Select this check box to turn on flow control on a port. See
for more on flow control.
Select all to have the interface accept all Ethernet frames. Select tag to have the interface
only accept frames with an IEEE 802.1Q VLAN tag.
Specify the port VLAN ID (1~4094) and IEEE 802.1p priority (0~7) to add to untagged
frames received on this port.
If you configure an ENET PVID setting and enable TLS, the system does not apply the
PVID.
Select a rate limit profile to apply to the subscriber connected to this port. The profile sets
maximum speed settings for traffic coming from or going to the subscriber. See
11.26 on page 406 for how to configure a profile.
Select a profile of per-queue rate limiting parameters to assign to this port.
Set the port's Class of Service (CoS) scheduling method.
Select SPQ to use Strict Priority Queuing to service queues based on the traffic's IEEE
802.1p priority only. When the highest priority queue empties, traffic on the next highest-
priority queue begins.
Select WRR to use Weighted Round Robin (WRR) scheduling to service queues on a
rotating basis based on their queue weight (the number you configure in the queue weight
fields). Queues with larger weights get more service than queues with smaller weights.
If you select WRR, use the Q0 to Q7 fields to set the priority weight (0~15) of each IEEE
802.1p priority queue. The higher a queue's weight, the more service it gets.
Click the Setup button to open a screen where you can configure the VLAN settings for the
port. See Section 9.28.2 on page 299
For a port on an Ethernet line card, click the Setup button to open a screen where you can
configure the link aggregation settings for the port. See
more information.
Click the Setup button to open a screen where you can configure Protocol VLAN (PVLAN)
settings for the port. See Section 9.8.9 on page 240
Click the Setup button to open a screen where you can configure VLAN translation settings
for the port. See Section 9.8.10.1 on page 242
Select this to turn on transmission for the GLC's SFP slot.
Manually select a speed for the GLC's SFP slot or use auto to let the system automatically
determine the speed to use.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Section 13.13.2 on page 532
for more information.
Section 9.28.3 on page 300
for a similar description.
for a similar description.
Management Switch Card User's Guide
Section
for