ZyXEL Communications MSC1000G User Manual page 157

Table 60 Alarm Descriptions (continued)
ALARM
LT_ACTIVE
LT_INACTIVE
LT_FW_UPLOAD_OK
LT_FW_UPLOAD_FAIL
LT_ENABLE
LT_DISABLE
LT_RESET
NT_SWITCH_OVER
CPU_UTIL_HIGH
VOP_BATTERY_FAIL
VOP_CLOCK_FAIL
VOP_RINGER_FAULT
PKTBUFF_LOW
MEMORY_USAGE_HIGH
STP_NEW_ROOT
STP_PORT_STATE_CHANG
E
STP_PORT_ROLE_CHANGE
System
REBOOT
CONFIG_CHANGE
CONFIG_UPLOAD_OK
CONFIG_UPLOAD_FAIL
TIME_SYNC_FAIL
ALARM_CUT_OFF
ALARM_CLEAR
LOGIN_FAIL
LOGIN_OK
ACCOUNT_ADD
ACCOUNT_DELETE
ACCOUNT_MODIFY
SVR_SYNC_PROF_OK
SVR_SYNC_PROF_FAIL
Management Switch Card User's Guide
SEVERITY MSC ALC SLC VLC VOP IMA DESCRIPTION
INFO X
MAJOR X
INFO X X
MAJOR X X
INFO X
INFO X
INFO X
MAJOR X
MAJOR X
CRITICAL
CRITICAL
CRITICAL
MAJOR
MAJOR
MINOR
MINOR
MINOR
INFO X
INFO X
INFO X
MAJOR X
MINOR X
INFO X
INFO X
MINOR X
INFO X
INFO X
INFO X
INFO X
INFO X
INFO X
A line card became active.
A line card became inactive.
X Firmware was successfully uploaded to a
card.
X Firmware upload to a card failed.
Line card enabled.
Line card disabled.
Line card reset.
The MSC in standby mode becomes
active.
The MSC is overloading.
X A VOP card's battery failed.
X A VOP card's clock failed.
X A VOP card's ringer failed.
The buffer storage for packet
transmission is too low. This might cause
some incoming packets to be dropped.
The memory usage is too high.
Spanning Tree Protocol (STP) detects a
new root bridge.
STP detects a port's status changed.
STP detects a port's role changed.
The system restarted.
The system configuration has changed.
Uploading of the system configuration
was successful.
Uploading of the system configuration
failed.
Synchronizing the time with a timeserver
failed.
An administrator cutoff (canceled) an
alarm.
An administrator cleared the alarms.
A user failed to login.
A user logged in successfully.
A user account was added.
A user account was deleted.
A user's account was modified.
Server-initiated profile synchronization is
successful.
Server-initiated profile synchronization
failed.
Chapter 5 Alarm Screens
157