ZyXEL Communications MSC1000G User Manual page 314

Chapter 9 Subscriber Port Setup Screens
Table 147 Port > VDSL2 PAEPVC (continued)
LABEL
MUX
Priority
Acname
Svrcname
Hello Time
Apply
Cancel
314
DESCRIPTION
Select the encapsulation type (llc or vc) for this channel.
Select the priority level for the service provider's VLAN ID. "0" is the lowest priority level and "7"
is the highest.
This field is optional. Specify the hostname of a remote access concentrator if there are two
access concentrators (or BRAS) on the network or if you want to allow PAE translation to the
specified access concentrator. In this case, the system checks the AC name field in the BRAS's
reply PDU. If there is a mismatch, the system drops this PDU. You can use 1-31 printable ASCII
characters. Spaces are allowed.
This field is optional. Specify the name of the service that uses this PVC. This must be a service
name that you configure on the remote access concentrator. You can use 1-31 printable ASCII
characters. Spaces are allowed.
Specify the timeout, in seconds, for the PPPoE session. Enter 0 if there is no timeout.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to begin configuring the screen again.
Management Switch Card User's Guide