ZyXEL Communications MSC1000G User Manual page 119

Figure 55 ACL > DSCP > Port
The following table describes the labels in this screen.
Table 38 ACL > DSCP > Port
LABEL
Slot
Port
Load
Enable
Apply
Cancel
Management Switch Card User's Guide
DESCRIPTION
Use the drop-down list boxes to select a line card and port.
Click Load to display the port's current settings.
Select this to have the Device map DSCP code points to IEEE 802.1p priorities for traffic the
Device sends out through this port.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Chapter 4 Access Control List Screens
119