Acl Macfilter Mode Command - ZyXEL Communications MSC1000G User Manual

Chapter 19 acl Commands

19.11.4 acl macfilter mode Command

Syntax:
acl macfilter mode <slot-port>|<slot-port-vpi/vci> accept|deny
where
accept|deny
This command sets the MAC filter action.
19.11.5 acl macfilter set Command
Syntax:
acl macfilter set <slot-port>|<slot-port-vpi/vci> <mac>
where
<mac> =
This command adds an allowed source MAC address on a line card's specified DSL port or on the
DSL port in all of the line cards DSL ports if no slot is specified. You can also specify a PVC on a DSL
port.
The following example adds source MAC address a0:c5:12:34:56:78 for DSL port 4 of the line card
in slot 5.
ras> acl macfilter set 5-4 a0:c5:12:34:56:78
19.11.6 acl macfilter show Command
Syntax:
acl macfilter show <slot>|<slot-port>|<slot-port-vpi/vci>
This command displays the MAC filtering status (V for enabled, - for disabled) and the fixed source
MAC addresses on a line card's specified DSL port(s) or on all of the line card's DSL ports if no port
is specified. You can also specify a PVC on a DSL port.
672
=
Allows frames from MAC addresses that you specify and block
accept:
frames from other MAC addresses.
Blocks frames from MAC addresses that you specify and allow frames
deny:
from other MAC addresses.
The source MAC address in "a0:c5:12:34:56:78" format.
Management Switch Card User's Guide