Acl Pppoeagent Optionmode Command - ZyXEL Communications MSC1000G User Manual

Chapter 19 acl Commands
The following example sets the switch to add "testing" as the line information to PPPoE discover
packets on VLAN 10.
ras> acl pppoeagent set 10
ras> acl pppoeagent enable 10
ras> acl pppoeagent info 10 testing
ras> acl pppoeagent show
vid en
---- ----- ------------------------
10 V
vlan set: 1
ras>

19.15.6 acl pppoeagent optionmode Command

Syntax:
acl pppoeagent optionmode <vid> private|tr101 [vid on|off]
This command selects the method (Private or TR-101) in which PPPoE line information is encoded in
PPPoE discover packets on the specified VLAN, and whether the VLAN ID is transmitted within the
packet or not. The vid on|off option applies to the TR-101 mode only. See
256 for more information on Private and TR-101 modes.
The following example sets VLAN 10 to use TR-101 encoding, and to transmit the VLAN ID in PPPoE
discover packets.
ras> acl pppoeagent optionmode 10 tr101 vid on
19.15.7 acl pppoeagent set Command
Syntax:
acl pppoeagent set <vid>
This command creates a PPPoE agent information entry for the VLAN. After you have created an
entry for a VLAN, you can configure the line information settings. The following example creates an
entry for VLAN 10.
ras> acl pppoeagent set 10
19.15.8 acl pppoeagent show Command
Syntax:
acl pppoeagent show
678
info
testing
Section 9.12 on page
Management Switch Card User's Guide