ZyXEL Communications MSC1000G User Manual page 312

Chapter 9 Subscriber Port Setup Screens
The following table describes the fields in this screen.
Table 146 Port > PAEPVC
LABEL
Slot
Port
Load
Index
VPI/VCI
Profile
MUX
PVID
Priority
Select
Modify
Copy
Delete
VPI/VCI
PVID
Profile
MUX
Priority
Acname
Svrcname
Hello Time
Apply
Cancel
312
DESCRIPTION
Select the number of a line card's slot. The corresponding subscriber port setup screen for the
type of line card you selected automatically displays.
Select the number of a DSL port on the line card.
Click Load to display the port's settings in the fields below.
This is the number of a PAEPVC entry on this port.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier (VCI), if any. The
VPI and VCI identify a channel on this port.
This field displays the VDSL2 profile that this channel uses.
This field displays the encapsulation type (llc or vc) for this channel.
This field displays the service provider's VLAN ID that this channel uses. The PVID here is the
service provider's VLAN ID (the outer VLAN tag) that the line card assigns to untagged frames
received on this PVC.
This field displays the service provider's priority settings that this channel uses. Priority is the
IEEE 802.1p priority level for the service provider tag that the line card adds to untagged
frames that come in on this PVC. "0" is the lowest priority level and "7" is the highest.
Select an entry's radio button and then click Modify to be able to edit it, click Copy to copy the
settings to another port or click Delete to remove it.
Select a profile's Select radio button and click Modify to edit the PAEPVC settings.
Select a profile's Select radio button and click Copy to copy the PAEPVC settings to another
port.
Select a profile's Select radio button and click Delete to remove the PAEPVC settings.
Type the Virtual Path Identifier and Virtual Circuit Identifier for a channel on the port. The VPI
and VCI identify a channel.
The PVID here refers to the service provider's VLAN ID (the outer VLAN tag). Enter the service
provider ID (from 1 to 4094) for untagged frames received on this PVC.
Note: Different PVCs can use the same service provider's VLAN ID.
Use the drop-down list box to select a VDSL2 profile to assign to this channel.
Select the encapsulation type (llc or vc) for this channel.
Select the priority level for the service provider's VLAN ID. "0" is the lowest priority level and "7"
is the highest.
This field is optional. Specify the hostname of a remote access concentrator if there are two
access concentrators (or BRAS) on the network or if you want to allow PAE translation to the
specified access concentrator. In this case, the system checks the AC name field in the BRAS's
reply PDU. If there is a mismatch, the system drops this PDU. You can use 1-31 printable ASCII
characters. Spaces are allowed.
This field is optional. Specify the name of the service that uses this PVC. This must be a service
name that you configure on the remote access concentrator. You can use 1-31 printable ASCII
characters. Spaces are allowed.
Specify the timeout, in seconds, for the PPPoE session. Enter 0 if there is no timeout.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to begin configuring the screen again.
Management Switch Card User's Guide