Switch Port Setup Dscp Screen - ZyXEL Communications MSC1000G User Manual

Chapter 13 Switch Screens

13.18.1 Switch Port Setup DSCP Screen

Click Switch > Switch Port Setup > DSCP in the navigation panel to display the screen shown
next. Use this screen to overwrite the IEEE 802.1p priority value of traffic received through an MSC
front panel Gigabit Ethernet interface based on its DSCP value. Use the ACL > DSCP > Setup
screen shown to configure the mapping between DSCP code points and IEEE 802.1p priorities for
subscribers (see
Figure 371 Switch Port Setup: DSCP
The following table describes the labels in this screen.
Table 285 Switch Port Setup: DSCP
LABEL
Port
Enable
Apply
Cancel
DSCP mapping
(codepoint/
priority)
Apply
Cancel
538
Section 4.18.1 on page 117).
DESCRIPTION
This is the label of a Gigabit Ethernet interface.
Select Enable to overwrite the IEEE 802.1p priority value of traffic received through the
selected Gigabit Ethernet interface based on its DSCP value.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Set the IEEE 802.1p priority (0~7) to use for the selected Gigabit Ethernet interface's
downstream traffic with each DSCP code point service level (0~63).
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Management Switch Card User's Guide