ZyXEL Communications MSC1000G User Manual page 172

Chapter 6 Diagnostic Screens
Figure 95 CFM Loopback
The following table describes the labels in this screen.
Table 69 CFM Loopback
LABEL
MD
MA
MEPID
Target
Count
Timeout
Test
LBM Index
Get Loopback
Data
172
DESCRIPTION
Select an MD name.
If the drop-down list is empty, create an MD in the Switch > CFM screen.
Select an MA name under the selected MD.
If the drop-down list is empty, create an MA in the Switch > CFM > CFM maintenance
association screen.
Select an MEP ID to specify which MEP port on the device initiates the test.
If the drop-down list is empty, create an MA in the Switch > CFM > CFM maintenance
association > CFM endpoint screen.
Specify the destination of the link you are checking. You can select MEPID and enter a remote
MEP's ID or select MAC and enter a remote MEP port's MAC address.
Specify how many times to perform the loopback connectivity test.
Specify how many milliseconds to wait for a reply to the loopback connectivity test.
Click this to start the loopback connectivity test.
Specify the number of a type of LBM (Loop Back Message) to display. Display a MEP ID's
results without specifying an LBM ID to display all of its LBM items with their ID numbers.
Click this to display the loopback test result.
Management Switch Card User's Guide