ZyXEL Communications MSC1000G User Manual page 222

Chapter 9 Subscriber Port Setup Screens
Table 98 VDSL Port Setup (continued)
LABEL
PMask
IPQoS Profile
Alarm Profile
Customer
Information
TEL
Frame Type
PVID / Priority
Advanced
Features
VLAN
PVLAN
XVLAN
Apply
Cancel
222
DESCRIPTION
Select this and click the 32 option bits link to apply standard mask(s) to the VDSL port.
The following screen displays.
Figure 136 PMask
Select one or more standard mask to use on this port and click Apply. The displayed
PMask value changes according to your setting. For example, 0x00003FF7 displays if you
select ALL; 0x00002000 displays if you only select G.993.2 17a.
Select an IPQoS profile to classify and prioritize application traffic flowing through this
port.
Select an alarm profile to define the thresholds that trigger an alarm on the port when
exceeded.
Enter information to identify the subscriber connected to this DSL port. You can use up to
31 printable English keyboard characters (including spaces and hyphens).
Enter information to identify the telephone number of the subscriber connected to this
DSL port. You can use up to 15 English keyboard characters (including spaces and
hyphens).
Select whether this port accepts both tagged and untagged incoming frames (all) or just
tagged incoming frames (tag).
Specify the port VLAN ID (1~4094) and IEEE 802.1p priority (0~7) to add to untagged
frames received on this port. If an untagged frame matches a PVLAN setting, the system
uses the PVLAN setting instead.
Click the Setup button to open a screen where you can configure the VDSL port's detailed
settings. See Section 9.8.2 on page 225
Click the Setup button to open a screen where you can configure the VLAN settings for
the VDSL port.
Click the Setup button to open a screen where you can configure Protocol VLAN (PVLAN)
settings for the VDSL port.
Click the Setup button to open a screen where you can configure VLAN translation
settings for the VDSL port.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
for more information.
Management Switch Card User's Guide