Loop Guard Slot Screen - ZyXEL Communications MSC1000G User Manual

Table 41 ACL > Loop Guard (continued)
LABEL
Copy
ID
State
Card Type
Up Time
Firmware

4.21.1 Loop Guard Slot Screen

Click the slot number of an active line card in the ACL > Loop Guard screen to display the screen
shown next. Use this screen to copy a port's loop guard settings to other ports.
Figure 63 ACL > Loop Guard: Slot
Management Switch Card User's Guide
DESCRIPTION
Do the following to copy the settings you configure above to another port or ports.
1. Click Copy.
2. Select the line card to which you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use Select All to
select every port. Use Select None to clear all of the check boxes.
4. Click Apply to paste the settings.
This is the slot number of a line card. Click the index number of an active line card to display
the Loop Guard - Slot screen where you can view and copy settings from one port to
another port or ports on the selected line card.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due to
the card starting, a firmware upgrade in progress or a malfunction. See
page 1111 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was started.
This field displays the current firmware version installed on the line card.
Chapter 4 Access Control List Screens
Section 38.7 on
127