where
<limitmask>
This command sets the PSD mask for the option bit on the specified port.
The following example sets the PSD mask to "VDSL2_A_NUS0" on traffic on port 5 on the VDSL
card in slot 4.
ras> port vdsl limitmask set 4-5 1
29.41.11 port vdsl limitmask show Command
Syntax:
port vdsl limitmask show <limit_mask>
Management Switch Card User's Guide
=
The PSD (Power Spectrum Density) mask.
limitmask:
1: VDSL2_A_NUS0
2~11: VDSL2_A_EU[32,36,40,44,48,52,56,60,64,128]
12: VDSL1_FTTEX_ANSI_M1
13: VDSL1_FTTEX_ANSI_M2
14: VDSL1_FTTCAB_ANSI_M1
15: VDSL1_FTTCAB_ANSI_M2
16: VDSL1_FTTEX_ANSI_M1_e
17: VDSL1_FTTEX_ANSI_M2_e
18: VDSL1_FTTCAB_ANSI_M1_e
19: VDSL1_FTTCAB_ANSI_M2_e
20: VDSL2_A_CT
21~36: VDSL2_B8_[1..16]
37~46: VDSL2_B7_[1..10]
47: VDSL2_BT_ANFP
48: VDSL2_C_138_b
49: VDSL2_C_276_b
50: VDSL2_C_138_co
51: VDSL2_C_276_co
Four additional customer-defined PSD shapes can be configured per system.
Chapter 29 port Commands
831