Figure 69 ACL > Arp Inspection
The following table describes the labels in this screen.
Table 46 ACL > Arp Inspection
LABEL
Slot
Port
Load
Enable
Apply
Cancel
Copy
Management Switch Card User's Guide
DESCRIPTION
Use the drop-down list boxes to select a line card and port.
Click Load to display the port's current settings.
Select Enable to activate ARP inspection on this port.
Clear this check box to disable ARP inspection on this port. This helps conserve the
system's resources.
Click Apply to save the changes in this part of the screen to the system's volatile
memory. The system loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy the settings you configure above to another port or ports.
1. Click Copy.
2. Select the line card to which you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use Select All to
select every port. Use Select None to clear all of the check boxes.
4. Click Apply to paste the settings.
Chapter 4 Access Control List Screens
135