Tunnel Protocol Attribute; Supported Radius Attributes - ZyXEL Communications MSC1000G User Manual

Management switch card
Hide thumbs Also See for MSC1000G:
Table of Contents

Advertisement

Table 315 Supported VSAs
FUNCTION
Egress Bandwidth
Assignment
Privilege Assignment

14.10.7.1 Tunnel Protocol Attribute

You can configure tunnel protocol attributes on the RADIUS server (refer to your RADIUS server
documentation) to assign a port on the system to a VLAN based on IEEE 802.1x authentication. The
port VLAN settings are fixed and untagged. This will also set the port's VID. The following table
describes the values you need to configure. Note that the bolded values in the table are fixed values
as defined in RFC 3580.
Table 316 Supported Tunnel Protocol Attribute
FUNCTION
VLAN Assignment

14.11 Supported RADIUS Attributes

Remote Authentication Dial-In User Service (RADIUS) attributes are data used to define specific
authentication and accounting elements in a user profile, which is stored on the RADIUS server.
This section lists the RADIUS attributes supported by the MSC.
Refer to RFC 2865 for more information about RADIUS attributes used for authentication. Refer to
RFC 2866 and RFC 2869 for RADIUS attributes used for accounting.
This section lists the attributes used by authentication functions on the MSC. In cases where the
attribute has a specific format associated with it, the format is specified.
Management Switch Card User's Guide
ATTRIBUTE
Vendor-Id = 890
Vendor-Type = 2
egress rate (Kbps in decimal format)
Vendor-data =
Vendor-ID = 890
Vendor-Type = 3
Vendor-Data = "shell:priv-lvl=N"
or
(CISCO)
Vendor-ID = 9
(CISCO-AVPAIR)
Vendor-Type = 1
Vendor-Data = "shell:priv-lvl=N"
where
is a privilege level (from 0 to 14).
N
Note: If you set the privilege level of a login account differently on the RADIUS server(s)
and the system, the user is assigned a privilege level from the database
(RADIUS or local) the system uses first for user authentication.
ATTRIBUTE
Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =
Note: You must also create a VLAN with the specified VID on the MSC.
VLAN ID
Chapter 14 Sys Screens
587

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msc1024gMsc1224gMsc1024gbMsc1024gcMsc1224gb

Table of Contents