Config Show Command - ZyXEL Communications MSC1000G User Manual

Chapter 22 config Commands
Table 351 config Commands (continued)
COMMAND
show
22.1.1 config default Command
Syntax:
ras> config default
This command resets the system to the factory default configuration. The system restarts with the
factory default settings.
Do not turn off your device while returning to the default configuration.
22.1.2 config save Command
Syntax:
ras> config save
This command saves your configuration when you are done with a configuration session. This
command saves all system configuration to nonvolatile memory. You must use this command to
save any configuration changes that you make, otherwise the system returns to its previously
saved settings when it is restarted. Save your changes after each configuration session.
Nonvolatile memory refers to the MSC's storage that remains even if the power is turned off.
Configuration saved in the run time (volatile) memory is lost when the power is turned off.
Do NOT turn off your device while saving your configuration.

22.1.3 config show Command

Syntax:
ras> config show sys|ip|switch|port|profile|acl|vlan|multicast|all [nopause]
This command shows the configuration of the specified category.
settings at one time so you do not need to press a key to continue.
694
upload <ip> <filename>
sys|ip|swit
ch|port|pro
file|acl|vl
an|multicas
t|all
[nopause]
DESCRIPTION
Uploads the specified configuration file to
the MSC from a TFTP server.
ip: a TFTP server's IP address
filename: the path and filename of the
configuration file on the TFTP server
Displays the current configuration.
allows you to show all
nopause
Management Switch Card User's Guide
P
8
1