ZyXEL Communications MSC1000G User Manual page 757

Table 364 port Commands (continued)
COMMAND
power
psd
set
uscarrier
copy <source>
<destination>
Management Switch Card User's Guide
param <slot-port>
[l0time <l0time>]
[l2time <l2time>]
[l2pcb <l2atpr>
<l2atprt>] [l2rate
<l2minrate>
<l2maxrate>
<l2threshold>]
<slot-port>
fix|power|rate
<max_us_tx>
<max_ds_tx>
<max_rx>
maximum [<slot-port>
<us-psd> <ds-psd>]
<slot-port> <profile>
<mode>
<slot-port> <m0> <m1>
DESCRIPTION
Sets the L0 (full power) and L2 (low power) power
mode transition settings.
: Time (10~ 65535 seconds) to stay in L0
l0time
mode.
: Time (10~65535 seconds) to wait
l2time
before performing another power trims in L2
mode.
: Maximum aggregated power reduction
l2atpr
(APTR) per trim in dB (0~
l2atprt
: Maximum total aggregate power
l2atprt
reduction in dB (0~15).
: Minimum rate in L2 (32~4096).
l2minrate
: Maximum rate in L2 (minimum L2
l2maxrate
rate ~ maximum upstream rate in kbps).
: Line rate threshold to stay in L2
l2threshold
mode. When the rate is not within the threshold,
the port switches to L0 mode immediately.
Specifies the maximum allowed transmission
power and maximum aggregate received power.
: PSD and power adaptivity:
fix|power|rate
fix: fixed mode
priority to power
:
power
rate: priority to rate
: maximum upstream transmission
max_us_tx
power (-130~200 in 0.1 dBm).
: maximum downstream transmit
max_ds_tx
power (-50~200 in 0.1 dBm).
: maximum aggregate receive power at
max_rx
atu-c (-255~255 in 0.1 dBm).
Sets/displays maximum upstream/downstream
nominal PSD values. This is for testing purposes.
us-psd: Upstream PSD (-400 ~ 40 in 0.1dBm/Hz).
ds-psd: Downstream PSD (-400 ~ 40 in 0.1dBm/
Hz).
Sets ADSL port(s) to use a profile created by the
command.
profile adsl set
:
mode
for Annex A, choose gdmt, t1413, glite, auto,
adsl2, or adsl2+.
for Annex B, choose gdmt, etsi, auto, adsl2,
or adsl2+.
Disables upstream carrier tones from 0 to 63.
: carrier tones, 0~ffffffff, '1' disables the
m0,m1
corresponding tone.
Copies port settings from a source port to
destination ports on the same type of line card.
Chapter 29 port Commands
P
8
).
8
8
8
8
8
757