Acl Dhcprelay82 Server Set Command - ZyXEL Communications MSC1000G User Manual

19.4.8 acl dhcprelay82 server set Command

Syntax:
acl dhcprelay82 server set <vid> <primary-server> [secondary-server]
where
<vid>
<primary-server>
<secondary-server> =
This command sets an entry for forwarding client DHCP requests received on a specific VLAN to the
DHCP server(s) at the specified IP address(es).
The following example sets 192.168.1.10 and 192.168.1.11 as the primary and secondary DHCP
servers respectively in VLAN 3.
ras> acl dhcprelay82 server set 3 192.168.1.10 192.168.1.11
19.4.9 acl dhcprelay82 set Command
Syntax:
acl dhcprelay82 set <vid>
This command creates a DHCP relay entry for the specified VLAN. After you have created an entry,
you can configure DHCP relay and relay option82 settings.
The following figure creates an entry for VLAN 10.
ras> acl dhcprelay82 set 10
19.4.10 acl dhcprelay82 show Command
Syntax:
acl dhcprelay82 show
This command displays whether or not the DHCP relay feature is activated, the DHCP server's IP
address, the status of the DHCP relay agent info option 82 feature and the information configured
for it. It also lists the DHCP relay server entries.
Management Switch Card User's Guide
=
A VLAN ID to be served with DHCP relay.
Note: The DHCP server(s) must be in the same VLAN.
=
The IP address of the primary DHCP server.
The IP address of the secondary DHCP server.
Chapter 19 acl Commands
659