Secured Client Screen - ZyXEL Communications MSC1000G User Manual

Figure 388 Access Control: Service Access Control
The following table describes the labels in this screen.
Table 301 Access Control: Service Access Control
LABEL
Services
Enable
Service Port
Apply
Cancel

14.3.1 Secured Client Screen

Click Sys > Access Control from the navigation panel and then the Secured Client tab to open
the following screen. Use this screen to configure IPv4 address ranges of trusted computers that
may manage the system.
Management Switch Card User's Guide
DESCRIPTION
These are services you may use to access the system are listed here.
Select the Enable check boxes for the corresponding services that you want to allow to
access the system.
For Telnet, SSH, SNMP, FTP, web, or HTTPS services, you can use this field to change the
service port number. If you change the port number then you will have to let people (who
wish to use the service) know the new port number for that service.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 14 Sys Screens
565