General Diagnostic Command Parameters - ZyXEL Communications MSC1000G User Manual

Chapter 23 diagnostic Commands

23.2 General diagnostic Command Parameters

The following table describes commonly used
Table 353 General diagnostic Command Parameters
NOTATION
md-name
ma-name
ep-id
remote-ep-id
mac
slot-port
slot-port-
vpi/vci
slot-gid
gid
link-id
23.3 diagnostic Commands Summary
The following table lists the
administrator privilege level needed to use the command.
Table 354 diagnostic Commands
COMMAND
diagnostic cfm
698
DESCRIPTION
The maintenance domain name (length<32).
The maintenance association name (length<16).
The endpoint identifier (1~8191).
The remote end point identifier (1~8191).
The remote end point's MAC address.
The number of a slot and a port on the slot. For example, 2-5 means port 5 on slot 2.
The number of a slot, a port on the slot and a channel. For example, 2-5-0/33 means a
channel with vpi 0 and vci 33 on port 5 of slot 2.
The card inserted in a slot, a port on that line card, and the VPI/VCI settings for the line
connected to that port, for example,: 3-1-0/33.
The number of a slot and an IMA group on the slot. For example, 2-1 means group 1 on
slot 2.
The ID of an IMA group (1~8).
The ID of an E1 link (1~8). Use a comma (,) to separate links whose IDs are not
continuous. Use Tilde (~) to specify continuous link IDs. For example, 1,3,5~7 means link
1, 3, 5, 6 and 7.
diagnostic
loopback set <md-name> <ma-
name> <ep-id>
[target <remote-
ep-id>|<mac>]
show <md-name> <ma-
name> <ep-id> [lbm-
id]
command parameter notation.
diagnostic
commands. The P column on the right indicates the
DESCRIPTION
Specifies the MD name, MA name, MEP ID, and
destination (MEP ID or MAC address) to perform
a loopback test.
This enables the MEP port (with the specified
MEP ID) in a specified CFM domain to send the
LBMs (Loop Back Messages) to a specified
remote end point.
Displays the loopback test results for the
specified MD name, MA name, MEP ID. You can
also specify the number of a type of LBM to
display. Display a MEP ID's results without
specifying an LBM ID to display all of its LBM
items with their ID numbers.
Management Switch Card User's Guide
P
8
8