Pnac Port Setup Screen - ZyXEL Communications MSC1000G User Manual

4.13 802.1X PNAC Port Setup Screen
Click ACL > 802.1X PNAC to display the screen shown next. PNAC stands for Port-based Network
Access Control. Use this screen to configure IEEE 802.1x settings.
Figure 48 802.1X PNAC: Port Setup
The following table describes the labels in this screen.
Table 31 802.1X PNAC: Port Setup
LABEL
Slot
Port
Load
Enable
Control
Reauthentication
Reauthentication
Period(s)
Apply
Management Switch Card User's Guide
DESCRIPTION
Use the drop-down list boxes to select a DSL or Gigabit Ethernet port on a line card for
which you wish to configure IEEE 802.1x authentication.
Click Load to display the port's current settings.
Select this check box to turn on IEEE 802.1x authentication on the system.
Select AUTO to authenticate all subscribers before they can access the network through
this port.
Select FORCE AUTHORIZED to allow all connected users to access the network through
this port without authentication.
Select FORCE UNAUTHORIZED to deny all subscribers access to the network through this
port.
Select On to have subscribers periodically re-enter their usernames and passwords to stay
connected to the port. Otherwise, select Off.
Specify how often a client has to re-enter his or her username and password to stay
connected to the port.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Chapter 4 Access Control List Screens
111