Profile Ratelimit Show Command - ZyXEL Communications MSC1000G User Manual

Chapter 30 profile Commands
The following creates an Ethernet subscriber line profile named test that limits ingress and egress
traffic to 12,800 Kbps.
ras> profile ratelimit set test 12800 12800

30.15.4 profile ratelimit show Command

Syntax:
profile ratelimit show [<profile>]
This command displays the name(s) of the rate limit profile(s) you have configured. Specify a
profile to see it's details.
ras> profile ratelimit show
rate limit profile(s):
----------------------
1. DEFVAL
2. test
ras> profile ratelimit show DEFVAL
rate limit profile : DEFVAL
ingress rate : 0 kbps
egress rate
30.16 profile shdsl Commands
Use the
profile shdsl
30.16.1 profile shdsl set Command
Syntax:
profile shdsl set <profile> <min-rate> <max-rate>
[annexa|annexb 2wire|4wire|mpair4
[lp_off | lp_on_cur [curr_margin] | lp_on_wc [worst_margin]]]
where
<profile>
<min-rate>
<max-rate>
annexa|annexb
888
: 0 kbps
commands to configure SHDSL profiles.
=
The descriptive name for the profile.
= The minimum transmission rate in Kbps (192~4096).
=
The maximum transmission rate in Kbps. (192~4096)
= The region setting, annexb is the default.
annexa
annexb
: DSL over POTS.
: DSL over ISDN.
Management Switch Card User's Guide