Switch Mac Aging Commands - ZyXEL Communications MSC1000G User Manual

Chapter 33 switch Commands
The following example sets mirroring to copy MSC port 3's outgoing traffic to port 4 so you can
examine it without affecting port 3's traffic flow. Then it activates mirroring and displays the
setttings.
ras> switch mirror port enet3 egress
ras> switch mirror monitorport enet4
ras> switch mirror enable
ras> switch mirror show
status
monitor port: enet4
port direction
------ ---------
enet1 none
enet2 none
enet3 egress
enet4 none
enet5 none
enet6 none
enet7 none
enet8 none

33.11 switch mac aging Commands

Syntax:
switch mac aging set <aging time>
switch mac aging show
where
aging time
Use these commands to configure and display the MAC aging out time period. This is how long all
dynamically learned MAC addresses remain in the MAC address table before they age out (and
must be relearned). This setting applies to both the MSC and any installed ELCs.
The following example displays the current MAC aging out period and then changes it to 500
seconds.
ras> switch mac aging show
Aging time : 300
ras> switch mac aging set 500
33.12 switch mstp Commands
Use the
switch mstp
1014
: Enable
=
Enter a number of seconds from 10 to 10,000. Enter 0 to disable the aging out of
MAC addresses.
commands to configure multiple spanning tree settings on the system.
Management Switch Card User's Guide