Port Paepvc Show Command - ZyXEL Communications MSC1000G User Manual

This command creates a PPPoA-to-PPPoE PVC to allow communication between the ATM (CPE) and
Ethernet network (BRAS) segments. The PVC is mapped to a PPPoE session that connects to the
specified BRAS.
The following example creates a PPPoA-to-PPPoE PVC (
The PVC uses
is for the
video
timeout before terminating the PPPoE session.
ras> port paepvc set 3-1-1/33 DEFVAL llc 2 1 acname vom srvcname video hellotime 10

29.24.3 port paepvc show Command

Syntax:
port paepvc show <slot>|<slot-port>|<slot-port-vpi/vci>
This command displays the PPPoA-to-PPPoE PVC settings for the specified port and/or slot.
The following example displays the settings on the line card in slot 3.
ras> port paepvc show 3
pvc
-------------- ------- ----- ------ ---- ----- --------------------------
3-1-1/33
ras>
29.25 port pots cid set Command
Syntax:
port pots cid set <slot-port> <AS-type> <payload-type>
where
<
AS-type
<
payload-
>
type
This command sets the AS type and payload type of CID (Caller Identification).
Management Switch Card User's Guide
encapsulation and the
llc
service on the access concentrator. The switch waits until the
vom
type mux pvid
pae llc
> = This sets the the AS type of CID, 0~5
0: DEFVAL (use the setting of country code)
1: CID during ring
2: DTAS CID before ring
3: RPAS CID before ring
4: LR DTAS CID before ring
5: LR CID before ring
=
This sets the payload type of CID, 0~8
0: DEFVAL (use the setting of country code)
1: MDMF
2: SDMF
3: ETSI MDMF
4: ETSI SDMF
5: DTMF
6: UK MDMF
7: UK SDMF
8: Japanese MDMF
) for port
1/33
ATM profile with a priority of
DEFVAL
pri htime profile/acname/srvcname
2 1 10 DEFVAL/test/example
Chapter 29 port Commands
on the line card in slot
1
. This configuration
1
hello time
809
.
3