Port Adsl Alarmprof Command - ZyXEL Communications MSC1000G User Manual

Chapter 29 port Commands

29.4.1 port adsl alarmprof Command

Syntax:
port adsl alarmprof <slot-port> <alarmprofile>
where
<alarmprofile>
This command applies (maps) an ADSL alarm profile to the subscriber port(s).
The following example sets ADSL port 5 on the line card in slot 7 to use the SESalarm alarm profile.
ras> port adsl alarmprofile 7-5 SESalarm
29.4.2 port adsl annexl disable Command
Syntax:
port adsl annexl disable <slot-port>
This command turns off the Annex L reach extended feature on the specified ADSL2 port(s).
The following example turns off the Annex L feature for port 5 on the line card in slot 75.
ras> port adsl annexl disable 5-7
29.4.3 port adsl annexl enable Command
Syntax:
port adsl annexl enable <slot-port> [narrow]
where
[narrow]
This command turns on the Annex L reach extended feature on the specified ADSL2 port(s). Annex
L can be used with Annex A (ADSL over POTS), not Annex B (ADSL over ISDN).
The following example turns on the Annex L feature for port 7 on the line card in slot 5.
ras> port adsl annexl enable 5-7
776
=
The name of an ADSL alarm profile.
=
The "narrow" PSD (Power Spectral Density) mode. The narrow mode supports
longer loop lengths but has lower transmission speeds.
The "wide" PSD mode is used if you do not enter "narrow". The wide mode
supports higher transmission speeds but requires shorter loop lengths.
Management Switch Card User's Guide