Port Sip Polarityreverse Command - ZyXEL Communications MSC1000G User Manual

where
<password>
This command sets a port on the VoIP line card to use the specified password with its SIP user
name.
The following example sets port 1 in card 4 to use "sip-test" as its SIP password.
ras> port sip account 4-1 sip-test

29.37 port sip polarityreverse Command

Syntax:
port sip polarityreverse <slot-port> <on|off>
Use this command to turn polarity reversal on or off. Turn on polarity reversal to reverse the tip and
ring after a call is established and again after it terminates. This is used for example, as a charging
signal for some types of payphone.
29.38 port sip set Command
Syntax:
port sip set <slot-port> <sip-profile> <svc-profile> [<dsp-profile>]
where
<sip-profile>
<svc-profile>
<dsp-profile>
This command sets a port on the VoIP line card to use the specified SIP, call service and DSP
profiles. By default, the VoIP line card's ports use the profile "DEFVAL" for all three kinds of profile.
The following example sets port 5 in card 4 to use the "sip123" SIP profile and the "svc456" call
service profile.
ras> port sip set 4-5 sip123 svc456
Management Switch Card User's Guide
= The password for registering the SIP account this port uses.
= The name of a SIP profile.
=
The name of a call service profile.
= The name of a digital signal processing profile.
Chapter 29 port Commands
823